J. Thomas Ltd. Applies the SPC method of inspection to assure our customers the utmost in quality assurance.During states of fabrication and upon completion each job
has a quality control sheet which is filled out and stays with the job. The inspector checks for appearance of materials, good quality (no rust or splatter) welds are
consistent in size, smooth and uniform to members being welded. Holes are the correct type, size and location. Coated as specified.
Fabrication is dimensionally checked. Overall height, width, length dimension are within drawing. tolerances. Placement of structural welded members, hole sizing, locations, tapped
holes, bend lines, material type and sizing, proper weld joining materials, location of welds & weld size are according to drawings tolerances.
All required testing has been performed. Mechanical assemblies operate completely, as per their design. Customers, special request, or requirements, have been addressed.
A final audit is done on all products before they are released for shipment.
J. Thomas Ltd. Applies the SPC method of inspection to assure our customers the utmost in quality assurance.
